Carving facets on dice

Australian Woodarts Bulletin Board: Decorative Turning Forum: Carving facets on dice
Ainslie Pyne, the Overseer No.1 (Admin) on Saturday, May 13, 2000 - 11:36 pm:

Hi folks,
Just found a new way of carving a range of different faceted dice utilising the decorative Turning Attachment by starting with either turned one inch cylinders, cones, doubled ended cones, or 1 inch balls.
Will post pictures on the website and be writing an article for a magazine, after I finish a commission for 3 sets of seven assorted shaped dice for a client in the US.
This is something that was not envisaged by the designer of the DTA unit - so this has opened a whole new direction for his invention !

By Ainslie Pyne, the Overseer No.1 (Admin) on Thursday, May 18, 2000 - 09:02 pm:

The Dice are finished.
View them on the following webpage with a brief description of how they were made.

Add a Message

This is a private posting area. A valid username and password combination is required to post messages to this discussion.